Member Sites  ::  JOIN  ::  Forum  ::  Info  ::  Next Ring  
Automotive Services Ring - The Automotive Services Web Ring is devoted to sites that deal with servicing ATVs, Cars, Trucks and Motorcycles, Auto p

  Forums     Login   Signup



Automotive Services Ring

Manager: idowebsites
Autos, automotive & motorsports community. Commercial and enthusiast membership. Automobile fanatics, auto dealerships, auto part shops, salvage yards, motorsports, racing, motorcycles and trucks are all relevant subject material.
 

Sponsored Links

Forum Posts - Start a new discussion! Posts 1 - 1 of 1
All Threads |   All Posts   ]

Chevrolet Epica engine fault lights, difficulty in starting - 11/13/2013

A mileage of about 100,000 km in 2009 Chevrolet Epica 1.8 sedan. User report: automobile engine fault lights , and at times difficult to start .



Inspection and analysis : detection of upkeep personnel by way of obd2 tool Tech2 diagnostic engine handle unit and discovered fault code P0341 ---- intake camshaft position sensor failure. The fault code can be cleared , however the engine will run for some time to reproduce .



Observed that the intake and exhaust camshaft position sensor and found them also towards the harness of diverse length , the other part of precisely the same ( Figure 17 ) . The two sensors reversed after the test , found fault remains.



Verify the engine idling, the intake camshaft phase , the phase value even located time for you to 122 °. Engine idling , in an effort to lessen the flow fluctuations proper to defer the phase in the intake camshaft is understandable , but normally postponed phase shouldn't exceed 100 °. Clear fault code abnormal because the data generated.



Get rid of the timing belt cover inspection, discovered the intake camshaft pulley timing mark on the existence of dislocation ( Figure 18 ) . The engine 's camshaft phase between the camshaft actuator should be to depend on an interference match connection , with pressure from the lock nut to provide. This strategy indicates that unlike the spline connection location is exceptional, hence the need for specific tools to install.

Troubleshooting: Inside the phase actuator ( camshaft pulley ) installed among the specific tools, hence ensuring the appropriate installation position . Then the common torque tighten the pulley nut . Test confirmed troubleshooting.perhaps you can use you cell phone just need X431 iDiag and app to contant automobile.

Chevrolet Epica engine fault lights, difficulty in starting




All Threads |   All Posts   ]





Contact Us | Copyright © 2001-2016 WebRing®, Inc. Terms of Service - Help - Privacy Policy